HealthRider E730 Elliptical Canadian English Manual - Page 6
Note: Either Console Plate Wire can be attached
View all HealthRider E730 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
4. Raise the Upright (3). Slide the M10 Flat Washer (94) onto the M10 x 25mm Button Screw (90). 4 Secure the Upright by tightening the M10 x 25mm Button Screw into the Frame (1). 3 90 94 5. Thread the Long Extension Wire (100) through the indicated hole in the Console Plate (101). Attach the Console Plate to the Upright (3) with four Console Plate Screws (39) and four M10 Split Washers (73). Make sure that the Long Extension Wire is not pinched between the Upright and the Console Plate. 5 101 100 73 6. Connect the Long Extension Wire (100) to the corresponding wire on the Console (97). Next, connect the two Console Plate Wires (106) to the two corresponding wires on the Console (97). Note: Either Console Plate Wire can be attached to either wire on the Console. Next, attach the ground wire to the indicated hole in the Console Plate (101) with an M4 x 16mm Screw (60). 7. Carefully feed all wires down through the Console Plate (101). Attach the Console (97) to the Console Plate with four M4 x 16mm Screws (60). Be careful to avoid pinching the wires. Refer to the inset drawing. Tap the Water Bottle Holders (87) into the indicated holes in the Console Plate (101). 39 6 Console Wires 106 101 7 101 1 3 97 60 Ground Wire 100 97 87 60 101 6