HP 2000fc HP StorageWorks 2012fc Modular Smart Array user guide (481597-001, M - Page 37
Correcting Enclosure IDs, Next Steps
View all HP 2000fc manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Correcting Enclosure IDs When installing a system with drive enclosures attached, the enclosure IDs might not agree with the physical cabling order. This is because the controller might have been previously attached to some of the same enclosures and it attempts to preserve the previous enclosure IDs if possible. To correct this condition, make sure that both controllers are up and perform a rescan using SMU or the CLI. This will reorder the enclosures, but can take up to two minutes for the enclosure IDs to be corrected. To perform a rescan using the CLI, type the following command: rescan To rescan using SMU, as an Advanced Manage user: 1. Select Manage > Utilities > Disk Drive Utilities > Rescan. 2. In the Rescan For Devices panel, click Rescan. Next Steps Now you are ready to connect the data and management hosts, as described in Chapter 3. Chapter 2 Installing and Cabling Enclosures 37