HP 300X HP JetDirect Print Servers 600N/400N/500X/300X Administrator's Guide - - Page 123
HP JetDirect Configuration Messages 117, Table 7.5, General HP JetDirect Messages 3 of 15 - jetdirect reset dhcp
UPC - 882780300842
View all HP 300X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 123 highlights
Table 7.5 General HP JetDirect Messages (3 of 15) Message Description DATA RATE: 4 Mbps 16 Mbps JUMPER ERROR The Token Ring data rate at which the HP JetDirect print server can transfer information. This setting should be either 4 or 16 Megabits per second (4 or 16 Mbps), depending on your network configuration. If the DATA RATE field displays JUMPER ERROR (older HP JetDirect print servers), check the jumper switch setting on the HP JetDirect print server. For information on setting the jumper switch on the print server, see the hardware installation guide for your print server. DATE MANUFACTURED Identifies the date of manufacture of the HP JetDirect print server. DHCP NACK After several attempts, the DHCP server has failed to acknowledge the configuration. The JetDirect print server will restart the configuration process. DISCONNECTED The Novell NetWare protocol is disconnected. Check the server and the print server. DISCONNECTING FROM SERVER The server has been shut down because of a configuration change or reset request. This message automatically clears after a few seconds, unless the printer is offline, is in an error state, or is servicing another I/O port or another network protocol. DISCONNECTING SPX TIMEOUT The SPX connection to the print server was lost after the connection had been made. This indicates a possible network problem, or a problem with the print server. Make sure all cables and routers are functioning correctly. Try restarting the print server. DUP NODE ADDRESS The HP JetDirect print server found another station on the ring that already has the address which the HP JetDirect print server wishes to use. Make sure that all addresses are unique. ERR NEGOTIATING BUFFER SIZE A failure was detected when selecting the buffer size to be used when reading print data from the file server. This may indicate a network problem. FAIL RESERVING PRINTER NUM When the HP JetDirect print server is configured for multiple file servers, the error is only displayed on the configuration page if none of the file servers was successfully connected. The SPX connection to the print server was lost when the HP JetDirect print server attempted to reserve the printer number. This indicates a possible network problem, or a problem with the print server. Make sure all cables and routers are functioning correctly. Try restarting the print server. EN HP JetDirect Configuration Page Messages 117