HP 300X HP JetDirect Print Servers 600N/400N/500X/300X Administrator's Guide - - Page 124
Table 7.5, General HP JetDirect Messages 4 of 15, Maximum of CRC Cyclic Redundancy Check errors
UPC - 882780300842
View all HP 300X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 124 highlights
Table 7.5 General HP JetDirect Messages (4 of 15) Message Description FIRMWARE REVISION: X.XX.XX The firmware revision number of the HP JetDirect print server currently installed in the printer. FRAME COPIED RCVD: Total number of Token Ring frames received with the frame copy error indicated in the Frame Status (FS) field. FRAMING ERROR Check the network topology and verify all cable segments. Check for damaged cables. FRAMING ERRORS RCVD: Maximum of CRC (Cyclic Redundancy Check) errors and framing errors. CRC errors are frames received with CRC errors. Framing errors are frames received with alignment errors. A large number of framing errors could indicate a cabling problem with your network. FS SET ERRORS RCVD: Total number of Token Ring frames with frame status set errors, indicating another node could not set the frame status. FUNCTION FAILURE The HP JetDirect print server is unable to transmit to itself while wrapped through its lobe at the Token Ring wiring concentrator. This message may also indicate that data frames were received before physical insertion. HARD ERROR The HP JetDirect print server is transmitting or receiving beacon frames to or from the ring. HP JETDIRECT JXXXXX Identifies the HP JetDirect print server model number. INITIALIZING TRYING TO CONNECT TO SERVER The HP JetDirect print server is trying to connect to the NetWare server(s). This is a normal message. Wait until the connection is established or another status message appears. INVALID GATEWAY ADDRESS The default gateway IP address specified for the HP JetDirect print server (through BOOTP or NOVRAM) is an invalid IP address for specifying a single node. INVALID IP ADDRESS The IP address specified for the HP JetDirect print server (through BOOTP or NOVRAM) is an invalid IP address for specifying a single node. INVALID SERVER ADDRESS The TFTP server IP address specified for the HP JetDirect print server (through BOOTP) is an invalid IP address for specifying a single node. INVALID SUBNET MASK The IP subnet mask specified for the HP JetDirect print server (through BOOTP or NOVRAM) is an invalid subnet mask. INVALID SYSLOG ADDRESS The syslog server IP address specified for the HP JetDirect print server (through BOOTP) is an invalid IP address for specifying a single node. 118 HP JetDirect Configuration Page Messages EN