HP AD510A HP StorageWorks 1500 Modular Smart Array Installation Guide (355901- - Page 39
Install the rails in the rack, provided with the rail kit.
UPC - 829160218625
View all HP AD510A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Installation Procedures - All Deployments c. Use a pencil to mark the required location of the scissor-like locking latches on the rails, as indicated by the template. d. Repeat these steps to mark the back of the rack, using the information on the back of the template as a guide. 2. If the holes in the rack uprights are round instead of square, remove the standard pins from the rails and replace them with the round-hold pins provided with the rail kit. WARNING: The pins in the rails are load-bearing. Do not remove the standard pins except to replace them with the pins for round-hole racks. 3. Install the rails in the rack: a. Identify the left (L) and right (R) rack rails by markings stamped into the rails. b. Insert the front end of the right rack rail into the inside front of the rack until the pins extend through the holes marked during the rack template procedure. Note: Be sure that the scissor-type locking latch engages when the end of the rail seats into the rack uprights. HP StorageWorks 1500 Modular Smart Array Installation Guide 39