HP Cisco MDS 9020 Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Rele - Page 12

Migrating from Supervisor-1 Modules to Supervisor-2 Modules Send documentation comments to [email protected] Table 6 Module Support Matrix for Cisco MDS SAN-OS 3.x (continued) Module DS-X9112 DS-X9124 DS-X9148 DS-X9704 DS-X9302-14K9 DS-X9016 DS-X9032 DS-X9032-SSM DS-X9308-SMIP DS-X9304-SMIP Description 12-port 4-Gbps Fibre Channel Switching Module 24-port 4-Gbps Fibre Channel Switching Module 48-port 4-Gbps Fibre Channel Switching Module 4-port 10-Gbps Fibre Channel Switching Module 14/2-port Multiprotocol Services (MPS-14/2) Module 16-port 1-, 2-Gbps Fibre Channel Switching Module 32-port 1-, 2-Gbps Fibre Channel Switching Module 32-port Storage Services Module (SSM) 8-port 1-, 2-Gbps IP Switching Module 4-port 1-, 2-Gbps IP Switching Module MDS 9500 Series Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes MDS 9222i Yes Yes Yes Yes No No No Yes No Yes MDS 9216i Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes MDS 9216A Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes MDS 9216 No No No No Yes Yes Yes Yes Yes Yes Migrating from Supervisor-1 Modules to Supervisor-2 Modules As of Cisco MDS SAN-OS Release 3.0(1), the Cisco MDS 9509 and 9506 Directors support both Supervisor-1 and Supervisor-2 modules. Supervisor-1 and Supervisor-2 modules cannot be installed in the same switch, except during migration. Both the active and standby supervisor modules must be of the same type, either Supervisor-1 or Supervisor-2 modules. For Cisco MDS 9513 Directors, both supervisor modules must be Supervisor-2 modules. Caution Migrating your supervisor modules is a disruptive operation. Note Migrating from Supervisor-2 modules to Supervisor-1 modules is not supported. To migrate from a Supervisor-1 module to a Supervisor-2 module, refer to the step-by-step instructions in the Cisco MDS 9000 Family CLI Configuration Guide. Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.1(1b) 12 OL-17675-02