HP Cisco MDS 9134 Cisco MDS 9000 Family Command Reference Guide - Release 4.x - Page 1578

tune-timer Chapter 23 T Commands Send documentation comments to [email protected] tune-timer To tune the Cisco SME timers, use the tune-timer command. To disable this command, use the no form of the command. tune-timer {global_lb_timer global_lb_timer_value | rscn_suppression_timer rscn_suppresion_timer_value | tgt_lb_timer tgt_lb_timer_value} no tune-timer {global_lb_timer global_lb_timer_value | rscn_suppression_timer rscn_suppresion_timer_value | tgt_lb_timer tgt_lb_timer_value} Syntax Description global_lb_timer global_lb_timer_value rscn_suppression_timer rscn_suppresion_timer_value tgt_lb_timer tgt_lb_timer_value Specifies the global load balancing timer value. Identifies the timer value. The range is from 5 to 30 seconds. The default value is 5 seconds. Specifies the Cisco SME Registered State Change Notification (RSCN) suppression timer value. Identifies the timer value. The range is from 1 to 10 seconds. The default value is 5 seconds. Specifies the target load balancing timer value. Identifies the timer value. The range is from 2 to 30 seconds. The default value is 2 seconds. Defaults None. Command Modes Cisco SME cluster configuration submode. Command History Release 3.3(1a) Modification This command was introduced. Usage Guidelines The tune-timer command is used to tune various Cisco SME timers such as the RSCN suppression, global load balancing and target load balancing timers. These timers should be used only in large scaling setups. The timer values are synchronized throughout the cluster. Examples The following example configures a global load balancing timer value: switch# config t switch(config))# sme cluster c1 switch(config-sme-cl)# tune-timer tgt_lb_timer 6 switch(config-sme-cl)# The following example configures a Cisco SME RSCN suppression timer value: switch# config t switch(config))# sme cluster c1 23-56 Cisco MDS 9000 Family Command Reference OL-18089-01, Cisco MDS NX-OS Release 4.x