HP Cisco MDS 9216i Cisco Nexus 5000 Series Command Reference Release 4.0(1a)N2 - Page 602
fcsp, Cisco Nexus 5000 Series Command Reference, OL-16599-01, Fibre Channel Commands
View all HP Cisco MDS 9216i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 602 highlights
Chapter 8 Fibre Channel Commands fcsp Send comments to [email protected] fcsp To configure an Fibre Channel Security Protocol (FC-SP) authentication mode for a specific interface in a FC-SP-enabled switch, use the fcsp command. To disable an FC-SP on the interface, use the no form of the command. fcsp {auto-active | auto-passive | on | off} [timeout-period] no fcsp Syntax Description auto-active auto-passive on off timeout-period Configures the auto-active mode to authenticate the specified interface. Configures the auto-passive mode to authenticate the specified interface. Configures the on mode to authenticate the specified interface. Configures the off mode to authenticate the specified interface. (Optional) Specifies the time out period to reauthenticate the interface. The time ranges from 0 (default-no authentication is performed) to 100,000 minutes. Command Default Auto-passive mode Command Modes Interface configuration mode Command History Release 4.0(0)N1(1a) Modification This command was introduced. Usage Guidelines To use this command, FC-SP must be enabled using the fcsp enable command. Examples The following example turns on the authentication mode for Fibre Channel interface in port 1 of slot 2: switch(config)# interface fc 2/1 switch(config-if)# fcsp on switch(config-if)# The following example reverts to the factory default of auto-passive for the selected interface: switch(config-if)# no fcsp The following example changes the selected interface to initiate FC-SP authentication, but does not permit reaunthentication: switch(config-if)# fcsp auto-active 0 8-68 Cisco Nexus 5000 Series Command Reference OL-16599-01