HP Dc7100 Getting Started - Page 17

Getting Started plug it in again. The computer will restart if automatic start on power loss is set in Computer Setup. If it does not restart, press the power button to start the computer. ■ Reconfigure your computer after installing a non-plug and play expansion board or other option. See "Solving Hardware Installation Problems" on page 20 for instructions. ■ Be sure that all the needed device drivers have been installed. For example, if you are using a printer, you need a driver for that model printer. ■ Remove all bootable media (diskette, CD, or USB device) from the system before turning it on. ■ If you have installed an operating system other than the factory-installed operating system, check to be sure that it is supported on the system. ■ If the system has multiple video sources (embedded, PCI, or PCI-Express adapters) installed (embedded video on some models only) and a single monitor, the monitor must be plugged into the monitor connector on the source selected as the primary VGA adapter. During boot, the other monitor connectors are disabled and if the monitor is connected into these ports, the monitor will not function. You can select which source will be the default VGA source in Computer Setup. Ä CAUTION: When the computer is plugged into an AC power source, there is always voltage applied to the system board. You must disconnect the power cord from the power source before opening the computer to prevent system board or component damage. Getting Started www.hp.com 13