HP J4819A User Manual - Page 33

Installing the Switch 5300xl Series Installation Procedures Installing the Switch 5300xl Series switch chassis LEDs hp procurve switch 5304xl J4850A Console Reset Clear Self Test Status 12ABCD Fan Power Modules Act FDx Max ! LED Mode Select switch module LEDs: Link and Mode LEDs for each port A procurve xl module J4820A Figure 2-6. Switch LEDs xl xl When the switch is powered on, it performs its diagnostic self test. The entire download, initialization, and self test process can take up to 2 minutes for a fully loaded chassis, depending on the number and type of modules installed in the switch. LED Behavior: During the self test: ■ Initially, Power and Fault, and all the switch chassis LEDs are on. Then, after approximately 30 seconds, all the module LEDs go on as the modules receive power and code is downloaded to them, the Fault LED goes off, and the chassis LEDs go off except Power, Self Test, Fan Status, and Power Status. ■ When the download of code to the modules is completed, the module LEDs go off. You may see each port LED go on briefly, in sequence, as the port is tested. ■ For the duration of the self test, the Self Test LED stays on. When the self test completes successfully: ■ The Power LED stays on, and the Status LEDs on the switch chassis stay on for the devices installed: one for each switch module installed, one for each power supply installed, and one for all the fans. ■ The Fault and Self Test LEDs are off. ■ The port LEDs on the switch modules go into their normal operational mode: • If the ports are connected to active network devices, the Link LEDs stay on and the Mode LEDs behave according to the mode selected. In the default mode (Activity), the Mode LEDs should flicker showing network activity on the port. • If the ports are not connected to active network devices, the LEDs will stay off. 2-13