HP J8698A User Manual - Page 42
Installing the Series 5400zl, Switches, Attaching Brackets to the 5400zl Switch
View all HP J8698A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Installing the Series 5400zl Switches Installing the Series 5400zl Switches Installation Procedures 8 mm M4 screws Figure 2-7. Attaching Brackets to the 5400zl Switch 2. Partially install a screw into the top hole of a pair of holes that are 0.5 inches apart in each rack/cabinet upright as shown in the illustration below. Ensure that the screws are at the same level in each upright. Partially install a screw into the top hole of a close (0.5-inch) pair on both sides of the rack Figure 2-8. Mounting Screw Positioning 3. Place the switch in the rack and lower it so the notches in the bottom of the bracket slide onto the screws, then tighten these screws. 2-18
2-18
Installing the Series 5400zl Switches
Installation Procedures
Installing the Series 5400zl
Switches
Figure 2-7.
Attaching Brackets to the 5400zl Switch
2.
Partially install a screw into the top hole of a pair of holes that are 0.5
inches apart in each rack/cabinet upright as shown in the illustration
below. Ensure that the screws are at the same level in each upright.
Figure 2-8.
Mounting Screw Positioning
3.
Place the switch in the rack and lower it so the notches in the bottom of
the bracket slide onto the screws, then tighten these screws.
8 mm
M4 screws
Partially install a screw
into the top hole of a
close (0.5-inch) pair on
both sides of the rack