HP J8698A User Manual - Page 65
Replacing the Management Module
View all HP J8698A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Replacing Components Replacing the Management Module Replacing the Management Module The switch does not have to be powered off to remove the management module, however when the management module is removed all ports will lose communication. ProCurve Networking recommends replacing the Management module, flash disk and battery (on the Management module) during scheduled down time. To install (or replace) a Management Module: 1. On the module unscrew the retaining screws enough to disconnect them from the threaded holes in the switch. 2. Using the extractor handles, pull the module out from the slot. 3. Remove the flash disk from the failed module and install it into the replacement module. 4. Remove the battery from the failed module and dispose of properly. 5. Install the new battery that came with the replacement module. See the following pages for replacement instructions. 6. Install the replacement module into the switch. 7. Use an equal amount of pressure and push both extractor handles closed to completely seat the module. 8. Tighten the retaining screws. Retaining Screws Extractor Handles Replacing Components 4-5