HP Media Center m7200 Upgrading and Servicing Guide - Page 7

Replacing the Side Panel, Removing the Front Panel

Get HP Media Center m7200 - Desktop PC PDF manuals and user guides View all HP Media Center m7200 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

Replacing the Side Panel 1 Slide the side panel forward on the frame until it locks into place. 2 Align the thumbscrews on the side panel with the holes on the back of the chassis frame, and then tighten the thumbscrews on the side panel. 3 See "After Closing the PC" on page 2. Removing the Front Panel This procedure is necessary only when removing or replacing an optical drive, a memory card reader, or a hard disk drive. 1 Locate the three small tabs attached to the front panel on the side of the chassis. 2 Press each tab away from the center of the chassis. Press the top, the middle, and the bottom tab, and then gently remove the front panel. Replacing the Front Panel 1 Place the chassis upright, and then align the three tabs on the right side of the front panel with the correct holes on the chassis. 2 Guide the three small tabs on the left side of the front panel into the correct holes until the panel snaps into place. Upgrading and Servicing Guide 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
Replacing the Side Panel
1
Slide the side panel
forward on the
frame until it locks
into place.
2
Align the
thumbscrews on the
side panel with the
holes on the back
of the chassis
frame, and then
tighten the
thumbscrews on the
side panel.
3
See “After Closing the PC” on page 2.
Removing the Front Panel
This procedure is necessary only when removing or
replacing an optical drive, a memory card reader, or
a hard disk drive.
1
Locate the three small tabs attached to the front
panel on the side of the chassis.
2
Press each tab away from the center of the chassis.
Press the top, the middle, and the bottom tab, and
then gently remove the front panel.
Replacing the Front Panel
1
Place the chassis upright, and then align the three
tabs on the right side of the front panel with the
correct holes on the chassis.
2
Guide the three small tabs on the left side of the
front panel into the correct holes until the panel
snaps into place.
Upgrading and Servicing Guide
3