HP Photosmart Premium Fax All-in-One Printer - C309 Setup Guide - Page 13
D2 - Ethernet/ Wireless 802.11
View all HP Photosmart Premium Fax All-in-One Printer - C309 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
/ D2 - Ethernet/ Wireless (802.11) EN If you have additional computers on your ES Si dispone de otros equipos en la red, instale network, install the HP All-in-One software el software del dispositivo HP All-in-One en on each computer. cada equipo. Follow the onscreen instructions. Make sure that Siga las instrucciones que aparecen en pantalla. you choose the connection types between the Asegúrese de que selecciona el tipo de conexión network and your HP All-in-One (not between entre la red y el dispositivo HP All-in-One (no entre your computer and the network). el equipo y la red). EN Network Troubleshooting ES Solución de problemas de red www.hp.com/support EN Problem: After you run the Wireless Setup Wizard from the HP All-in-One control panel, the HP All-in-One cannot connect to the network. Action: • Run the Wireless Network Test. You can run this diagnostic test directly from the Wireless Setup Wizard or from the HP All-in-One front panel Network Menu. In the Network Menu, scroll down and select Wireless Network Test. After the test runs, a report is printed that lists any problems detected with your wireless network, along with recommendations on how you can correct it. • There may be inference from other devices preventing the HP All in One from connecting. Any wireless device that uses 2.4GHZ can cause interference (including microwaves). Make sure these devices are not in use during the HP All in One installation. • Your wireless router may need to be reset. Turn off your wireless router for 30 seconds and then turn it back on. Then run the Wireless Setup Wizard on your HP All in One. ES Problema: Una vez ejecutado el Asistente de instalación inalámbrica desde el panel de control de HP All-in-One, el dispositivo HP All-in-One no se puede conectar a la red. Acción: • Ejecute la prueba de la red inalámbrica. Puede ejecutar esta prueba de diagnóstico directamente desde el asistente de configuración inalámbrica o desde el menú Red del panel frontal de HP All-in-One. En el menú Red, baje y seleccione la prueba de red inalámbrica. Después de ejecutar la prueba, se imprime un informe con un listado con los errores que se hubieran detectado en la red inalámbrica, junto con recomendaciones sobre cómo corregirlos. • Es probable que haya interferencias procedentes de otros dispositivos que impidan que HP All-in-One se conecte. Cualquier dispositivo inalámbrico de 2,4 GHz puede causar interferencias (incluidos los microondas). Asegúrese de que estos dispositivos no estén en funcionamiento durante la instalación del dispositivo HP All-in-One. • Es posible que el direccionador inalámbrico tenga que volver a iniciarse. Apague el direccionador inalámbrico durante 30 segundos y vuelva a encenderlo. A continuación, ejecute el Asistente de instalación inalámbrica en el dispositivo HP All-in-One. HP Photosmart Premium Fax All-in-One Series-C309 • 13