HP ProLiant 1600 Migrating from SCO OpenServer 5.0.5 to UnixWare 7.1 Using Com - Page 30

Migrating from SCO OpenServer™ 5.0.5 to UnixWare® 7.1 Using Compaq SmartStart v4.23 30 Appendix B: Current OpenServer 5.0.5 System Configuration When SmartStart begins the System Configuration Utility, the following should appear on your screen. Review each item and modify as appropriate. Compaq ProLiant 1600 System Board Primary Operating System SCO OpenServer 5 Embedded IDE Controller Standard Interface Enabled as Second Controller Drive Type - Unit 1 CD-ROM Drive Type - Unit 2 Not Installed Advanced Features Alternative A20 Switching Enable Port 92 Software Generated NMI Disabled Fail-Safe Timer NMI Disabled Bus-Master Timeout NMI Disabled Parity Error Response Enabled Hot Plug Keyboard Enabled Erase non-volatile memory Select to erase non- volatile memory IOQ Setting IOQ = 8 F1 Boot Prompt Enabled - stop at prompt Hot-Plug Reservation Options Normal APIC Mode Full Table - Mapped Slot 3 - Compaq Fast Ethernet NIC NC3120 PCI 10/100 Network Resources Enabled Slot 4 - Compaq Fibre Channel PCI Controller Controller Resources Enabled Controller Order Fourth Drive Characteristics View with Compaq Array Configuration Utility Slot 5 - Compaq Smart Array 3200 Controller - Bus 1 Controller Resources Enabled Controller Order Fifth Online Recovery Server Status Disabled Drive Characteristics View with Compaq Array Configuration Utility SCSI Bus Speed Auto-detection 0413-0799-A