HP ProLiant 1600 Migrating from SCO OpenServer 5.0.5 to UnixWare 7.1 Using Com - Page 31
Appendix B: Current OpenServer 5.0.5 System Configuration (cont)
View all HP ProLiant 1600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Migrating from SCO OpenServer™ 5.0.5 to UnixWare® 7.1 Using Compaq SmartStart v4.23 31 Appendix B: Current OpenServer 5.0.5 System Configuration (cont) Cache Size 56 MB Firmware Revision 3.06 Bus 1 - PCI Mass Storage Controller PCI Function 1 Enabled Embedded - Compaq Automatic Server Recovery (ASR) Automatic Server Recovery Software error recovery Disabled Software error recovery time-out 10 minutes Standby recovery server option Disabled Standby recovery server port COM1 Standby recovery time-out 1 minute Software error recovery boot option .......... Boot operating system Thermal shutdown Disabled UPS shutdown Disabled UPS shutdown threshold 5 minutes Server Failure Notification Pager status Disabled Pager dial string None Pager message None Pager test Select to test pager setup Remote Options Serial interface COM2 Serial fixed baud rate None Port initialization commands None Modem initialization commands None Dial in status Disabled Dial out status Disabled Dial out string None Network status Disabled Network protocol IPX Network token-ring source routing Disabled Network controller Compaq Network host name None Network card slot Slot 3 Network frame type ETHERNET_802.3 Only) Network IP address None Network IP netmask None Network IP router address None (IPX Embedded - Compaq Integrated Remote Console (IRC) General IRC Information Remote Console Functions Disabled Embedded - Compaq Integrated Management Display Information 0413-0799-A