HP ProLiant xw2x220c HP ProLiant xw2x220c Workstation Blade Maintenance and Se - Page 25
Workstation A system board
View all HP ProLiant xw2x220c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
5. Remove the mezzanine card. CAUTION: To prevent damage to the workstation blade, apply pressure over the mezzanine connector when installing the mezzanine card. Do not apply pressure to the edges of the card. To replace the component, reverse the removal procedure. Workstation A system board To remove the component: 1. Power down the workstation blade (on page 11). 2. Remove the workstation blade (on page 11). 3. Access the internal workstation components (on page 12). 4. Remove the workstation A USB key, if installed. 5. If installed, remove one of the following: o Hard drive (on page 13) o Cache module battery (on page 22) 6. Remove all DIMMs ("DIMMs" on page 15). 7. Remove any mezzanine cards ("Mezzanine card" on page 24). 8. Remove the heatsink ("Heatsink" on page 15). 9. Remove the cache module battery cable, if installed. Removal and replacement procedures 25