HP Scitex FB550 Scitex FB550 and FB750 Printers- Cleaning Instructions - Page 21

Replace the service station wiper, Proceed

Get HP Scitex FB550 PDF manuals and user guides View all HP Scitex FB550 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

4. Vacuum the filter (A in photo below.) located under the printer's chassis near the power cord attachment point, and remove dust from the surrounding area. Figure 19 Cleaning dust from the electronics box fan filter 5. To reset the maintenance counter for this task and complete the procedure, press Proceed. Replace the service station wiper CMYKcm - 250 Hours CMYKW - 250 Hours The wiper blade deteriorates with use. Replacing the wiper blade periodically restores the wiping to optimal performance and wiper height. NOTE: Replace the wiper according to the schedule in Table 1 Schedule of cleaning tasks on page 2. The wiper replacement schedule is calculated to be frequent enough to avoid the need for wiper-height calibrations between replacements. If the wipers are not making adequate contact with the printheads, contact your service provider to calibrate the wiper height. 1. Select from the control panel System> Tools> User Cleaning and Maintenance> 11) Replace Service Station Wiper. 2. Press Proceed to continue. 3. Open the service door to access the service station. ENWW Replace the service station wiper 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
4.
Vacuum the filter (A in photo below.) located under the printer's chassis near the power cord
attachment point, and remove dust from the surrounding area.
Figure 19
Cleaning dust from the electronics box fan filter
5.
To reset the maintenance counter for this task and complete the procedure, press
Proceed
.
Replace the service station wiper
CMYKcm
—
250 Hours
CMYKW
—
250 Hours
The wiper blade deteriorates with use. Replacing the wiper blade periodically restores the wiping to optimal
performance and wiper height.
NOTE:
Replace the wiper according to the schedule in
Table
1
Schedule of cleaning tasks
on page
2
. The
wiper replacement schedule is calculated to be frequent enough to avoid the need for wiper-height
calibrations between replacements. If the wipers are not making adequate contact with the printheads,
contact your service provider to calibrate the wiper height.
1.
Select from the control panel
System> Tools> User Cleaning and Maintenance> 11) Replace Service
Station Wiper
.
2.
Press
Proceed
to continue.
3.
Open the service door to access the service station.
ENWW
Replace the service station wiper
19