HP Scitex FB550 Scitex FB550 and FB750 Printers- Cleaning Instructions - Page 23
Drain waste ink container, Proceed
View all HP Scitex FB550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
3. Remove the output table and open the output-side door. 4. Using the brush supplied with the printer (shown in the photo below), clean the ionizer needles (A in the photo below) beneath the ionizer bar. The ionizer bar is located between the input roller and the alignment bar on the input side of the printer. Figure 22 Cleaning ionizer needles with supplied brush The needles (A in the photo below) run the length of the ionizer bar. Figure 23 Ionizer needles 5. To reset the maintenance counter for this task and complete the procedure, press Proceed . Drain waste ink container CMYKcm - 40 Hours CMYKW - 20 Hours Waste ink accumulates in the service station until drained. Depending on printer use and ink service frequency the service station may need to be drained more often, a Warning or Action in the Attention Queue will alert the user when the float in the service station detects it is full. Dispose of the collected ink according to local regulations. 1. Place the waste ink container (included with the printer) beneath the waste ink spigot, under the media drive belt at the service-end of the printer. 2. Select from the control panel System> Tools> User Cleaning and Maintenance> 13) Drain Waste Ink Container. 3. Press Proceed to continue. ENWW Drain waste ink container 21