HP Scitex FB550 Scitex FB550 and FB750 Printers- Cleaning Instructions - Page 24
Clean media thickness sensor, Proceed
View all HP Scitex FB550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
4. Turn the spigot (A in the photo below) to the open position Figure 24 Waste ink bottle and spigot 5. Turn the spigot to the closed position after the waste ink has drained. Figure 25 Waste ink spigot in the closed position CAUTION: The drain spigot must remain closed during printing and service station use. An open spigot affects the vacuum level in the service station and will degrade service station performance if left open. 6. To reset the maintenance counter for this task and complete the procedure, press Proceed. Clean media thickness sensor CMYKcm - 250 Hours CMYKW - 250 Hours The media thickness sensor is located on the carriage rail, on the user-end behind the rail. Debris on the media thickness sensor roller can result in inaccurate measurements. Clean the roller to keep the sensor operating correctly. NOTE: Users of printers in California must disregard all references to the Printhead Flush or IPA in the instructions or when displayed on the control panel. Instead, the alternative cleaning liquid specified at the beginning of this section must be used. 1. Select from the control panel System> Tools> User Cleaning and Maintenance> 14) Clean Media Thickness Sensor. 2. Press Proceed to continue. 22 User cleaning ENWW