HP SignagePlayer mp8000r Maintenance & Service Guide: HP SignagePlayer mp8 - Page 120

Hard Drive

Get HP SignagePlayer mp8000r PDF manuals and user guides View all HP SignagePlayer mp8000r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 120 highlights

Hard Drive NOTE: The Ultra-Slim Desktop supports only 2.5-inch Serial ATA (SATA) internal hard drives; parallel ATA (PATA) internal hard drives are not supported. Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you can transfer the data to the new hard drive. The 2.5-inch hard drive is enclosed in a carrier under the optical drive. 1. Prepare the computer for disassembly (Preparation for Disassembly on page 92). 2. If the computer is on a stand, remove the computer from the stand and lay the computer down. 3. Remove the computer access panel (Computer Access Panel on page 99). 4. Remove the optical drive. Refer to Removing the Existing Optical Drive on page 107 for instructions. 5. Press in the release latch on the left side of the hard drive carrier (1) then rotate the carrier handle to the right (2). Figure 7-19 Unlocking the Hard Drive Carrier 110 Chapter 7 Removal and Replacement Procedures Ultra-Slim Desktop (USDT) Chassis

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
Hard Drive
NOTE:
The Ultra-Slim Desktop supports only 2.5-inch Serial ATA (SATA) internal hard drives; parallel
ATA (PATA) internal hard drives are not supported.
Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you
can transfer the data to the new hard drive.
The 2.5-inch hard drive is enclosed in a carrier under the optical drive.
1.
Prepare the computer for disassembly (
Preparation for Disassembly
on page
92
).
2.
If the computer is on a stand, remove the computer from the stand and lay the computer down.
3.
Remove the computer access panel (
Computer Access Panel
on page
99
).
4.
Remove the optical drive. Refer to
Removing the Existing Optical Drive
on page
107
for
instructions.
5.
Press in the release latch on the left side of the hard drive carrier
(1)
then rotate the carrier handle
to the right
(2)
.
Figure 7-19
Unlocking the Hard Drive Carrier
110
Chapter 7
Removal and Replacement Procedures Ultra-Slim Desktop (USDT) Chassis