HP SignagePlayer mp8000r Maintenance & Service Guide: HP SignagePlayer mp8 - Page 78
Installing a Drive into the 3.5-inch Drive Bay Media Card Reader Shown,
View all HP SignagePlayer mp8000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
3. Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive toward the front of the computer until it locks into place. Figure 6-39 Installing a Drive into the 3.5-inch Drive Bay (Media Card Reader Shown) 4. Connect the appropriate drive cables: a. If installing a second hard drive, connect the power and data cables to the rear of the drive and connect the other end of the data cable to the next available (unpopulated) SATA connector on the system board by following the numbered sequence of the connectors. b. If installing a media card reader, connect the USB cable from the media card reader to the USB connector on the system board labeled MEDIA. If the media card reader includes a 1394 port, connect the 1394 cable to the 1394 PCI card. NOTE: Refer to System Board Drive Connections on page 60 for an illustration of the system board drive connectors. 5. Replace the 5.25-inch drive. 6. Replace the front bezel and access panel. 7. If the computer was on a stand, replace the stand. 8. Reconnect the power cord and turn on the computer. 9. Lock any security devices that were disengaged when the access panel was removed. 68 Chapter 6 Removal and Replacement Procedures Small Form Factor (SFF) Chassis