HP SignagePlayer mp8000r Maintenance & Service Guide: HP SignagePlayer mp8 - Page 79
Removing and Replacing the Primary 3.5-inch Internal SATA Hard Drive
View all HP SignagePlayer mp8000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Removing and Replacing the Primary 3.5-inch Internal SATA Hard Drive NOTE: The system does not support Parallel ATA (PATA) hard drives. Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you can transfer the data to the new hard drive. The preinstalled 3.5-inch hard drive is located under the power supply. To remove and replace the hard drive: 1. Prepare the computer for disassembly (Preparation for Disassembly on page 35). 2. If the computer is on a stand, remove the computer from the stand. 3. Remove the access panel (Computer Access Panel on page 43). 4. Rotate the drive cage for external drives to its upright position. Figure 6-40 Rotating the Drive Cage Up Drives 69
Removing and Replacing the Primary 3.5-inch Internal SATA Hard Drive
NOTE:
The system does not support Parallel ATA (PATA) hard drives.
Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you
can transfer the data to the new hard drive.
The preinstalled 3.5-inch hard drive is located under the power supply. To remove and replace the
hard drive:
1.
Prepare the computer for disassembly (
Preparation for Disassembly
on page
35
).
2.
If the computer is on a stand, remove the computer from the stand.
3.
Remove the access panel (
Computer Access Panel
on page
43
).
4.
Rotate the drive cage for external drives to its upright position.
Figure 6-40
Rotating the Drive Cage Up
Drives
69