HP SignagePlayer mp8000r Maintenance & Service Guide: HP SignagePlayer mp8 - Page 133
System Board
View all HP SignagePlayer mp8000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
System Board CAUTION: Be very careful when removing or replacing the system board to prevent damaging it. 1. Prepare the computer for disassembly (Preparation for Disassembly on page 92). 2. Remove the computer access panel (Computer Access Panel on page 99). 3. Remove the optical drive (Removing the Existing Optical Drive on page 107). 4. Remove the memory modules (Installing Additional Memory on page 102). 5. Remove the front fan (Front Fan on page 116). 6. Remove the hard drive (Hard Drive on page 110). 7. Remove the hard drive cage (Hard Drive Cage on page 114). 8. Remove the front I/O panel cage: a. Remove the screw from the right side of the cage that secures the I/O panel cage to the front of the chassis (1). b. Press the tab on right side of the cage (2), and then swing the right side of the cage away from the chassis to remove it (3). NOTE: If the cage sticks and will not come loose, press down on the top of the panel near the tab while pressing the tab. Figure 7-35 Removing the I/O panel cage 9. Remove the heat sink (Heat sink on page 119). 10. Disconnect all cables connected to the system board, noting their location for reinstallation. System Board 123