HP SignagePlayer mp8000s Maintenance & Service Guide: HP SignagePlayer mp8 - Page 134
Rear Fan, Preparation for Disassembly, on Computer Access Panel, TV Tuner Module
View all HP SignagePlayer mp8000s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 134 highlights
11. Remove the three remaining screws that secure the system board to the chassis. Figure 7-36 Removing the system board 12. Slide system board toward the front of the unit until the rear connectors are clear of their slots in the chassis. 13. Lift the rear of the system board until it clears the chassis, and then remove the system board from the chassis. To install the system board, reverse the removal procedure. NOTE: When replacing the system board, you must also change the chassis serial number in the BIOS. Rear Fan The rear fan is secured to the rear right corner of the chassis. You must remove the system board before you can remove the rear fan. 1. Prepare the computer for disassembly (Preparation for Disassembly on page 92). 2. Remove the computer access panel (Computer Access Panel on page 99). 3. Remove the system board (TV Tuner Module on page 122). 4. Disconnect the fan control cable from the red/brown system board connector labeled CHFAN2. 124 Chapter 7 Removal and Replacement Procedures Ultra-Slim Desktop (USDT) Chassis