HP SignagePlayer mp8000s Maintenance & Service Guide: HP SignagePlayer mp8 - Page 72
Installing an Optical Drive into the 5.25-inch Drive Bay, CAUTION,
View all HP SignagePlayer mp8000s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
6. Rotate the drive cage back down to its normal position. CAUTION: Be careful not to pinch any cables or wires when rotating the drive cage down. Figure 6-29 Rotating the Drive Cage Down 7. Press down on the green drive retainer button located on the left side of the drive to disengage the drive from the drive cage (1). While pressing the drive retainer button, slide the drive back until it stops, then lift it up and out of the drive cage (2). Figure 6-30 Removing the 5.25-inch Drive NOTE: To replace the drive, reverse the removal procedure. When replacing a drive, transfer the four guide screws from the old drive to the new one. Installing an Optical Drive into the 5.25-inch Drive Bay To install an optional 5.25-inch optical drive: 1. Prepare the computer for disassembly (Preparation for Disassembly on page 35). 2. If the computer is on a stand, remove the computer from the stand. 3. Remove the access panel (Computer Access Panel on page 43). 62 Chapter 6 Removal and Replacement Procedures Small Form Factor (SFF) Chassis