HP StorageWorks 1606 Brocade Converged Enhanced Ethernet Command Reference v6. - Page 143

Chapter Spanning Tree Protocol Commands 9 bridge-priority Specifies the priority of the bridge. Synopsis bridge-priority priority no bridge-priority Operands priority Specifies the bridge priority. The range of valid values is 0-61440. Defaults The default priority is 32678. Command Protocol Spanning Tree mode Modes Description Use this command to set the bridge priority for the common instance. Using a lower priority value indicates that the bridge might become root. Use the no bridge-priority command to return to the default settings. Usage This command must be used to specify the priority of the bridge. The priority values can be set only Guidelines in increments of 4096. Examples To specify the bridge priority: switch#configure terminal switch(config)#protocol spanning-tree stp switch(conf-stp)#bridge-priority 8192 switch#configure terminal switch(config)#protocol spanning-tree rstp switch(conf-rstp)#bridge-priority 8192 switch#configure terminal switch(config)#protocol spanning-tree mstp switch(conf-mstp)#bridge-priority 8192 see Also protocol spanning-tree Converged Enhanced Ethernet Command Reference 125 53-1001347-01