HP StorageWorks 1606 Brocade Converged Enhanced Ethernet Command Reference v6. - Page 227

dot1x timeout tx-period 12 dot1x timeout tx-period Sets the number of seconds that the switch waits for a response to an Extensible Authentication Protocol (EAP) request or identity frame from the client before retransmitting the request. Synopsis dot1x timeout tx-period seconds Operands seconds Specifies the time in seconds between successive request ID attempts. The range of valid values is 1-65535. Defaults The default timeout is 30 seconds. Command Interface configuration mode Modes Description Use this command to set the interval between successive attempts to request an ID (EAP ID Req). Usage There are no usage guidelines for this command. Guidelines Examples To set 34 as the number of seconds to wait for a response to an EAP-request or identity frame from the client before retransmitting the request: switch(config)#interface tengigabitethernet 0/1 switch(config-if)#dot1x timeout tx-period 34 See Also none Converged Enhanced Ethernet Command Reference 209 53-1001347-01