HP StorageWorks 2/32 SAN switch universal rack mount kit installation addendum - Page 2

Pen-and-ink Changes

2

SAN Switch Universal Rack Mount Kit Installation Addendum

This addendum consists two parts:

■

Pen-and-ink Changes

—provides instructions for locating specific text and

either deleting text, replacing text with new text, or adding new text at a

specific location.

■

Page Additions

—identifies where to add a page at a specific place in the

document and recommends how to attach the replacement pages.

Note:

If the changes within this addendum are not incorporated into the specified

documents and then used, problems might arise from using obsolete information.

Pen-and-ink Changes

There are no pen-and-ink changes in this addendum.

Page Additions

The following pages describe the installation of the SAN Switch 2/32, SAN

Switch 2/16, and SAN Switch 2/8 in an HP Series 9000 or comparable EIA rack,

or in an HP System/e rack using the SAN Switch Universal Rack Mount Kit, part

number 331148-B21.

For each document, insert the following sheets as shown here:

1.

After page 30 in the

HP StorageWorks SAN Switch 2/32 Installation Guide

2.



3.



Section	Page
Pen-and-ink Changes	2
Page Additions	2
Installing the Switch in a Rack Using the SAN Switch Universal Rack Mount Kit	3
Figure 1: SAN Switch 2/16 rack-mounted switch	3
Figure 2: Installing the rear mounting brackets (HP 9000 Series or comparable EIA rack)	5
Figure 3: Installing the rear mounting brackets (HP System/e rack-left rear upright)	6
Figure 4: Installing the outer rails (HP 9000 Series or comparable EIA rack)	7
Figure 5: Assembling the outer rails (HP 9000 Series or comparable EIA rack)	8
Figure 6: Assembling the outer rails (HP System/e rack)	9
Table 1: Number of screws required to assemble the inner rails	9
Figure 7: Assembling the inner rails	11
Figure 8: Assembling the inner rails on a SAN Switch 2/8 with plenum	12
Figure 9: Installing the switch into a rack (HP 9000 Series or comparable EIA rack)	13

HP StorageWorks 2/32 SAN switch universal rack mount kit installation addendum - Page 2

Pen-and-ink Changes, Additions, HP StorageWorks SAN Switch 2/32 Installation Guide

Page 2 highlights