HP StorageWorks 2/32 SAN switch universal rack mount kit installation addendum - Page 9

Installing the Switch in a Rack Using the SAN Switch Universal Rack Mount Kit

7

Addendum Pg

HP StorageWorks SAN Switch 2/8|16|32 Installation Guide

—

For an HP System/e rack, install two #10-32 x 1/2-inch Phillips pan-head

screws with captive star lock washers and two #10 alignment washers in

the upper and lower hole locations of the right rail. Then install two

#10-32 x 1/2-inch Phillips pan-head screws with captive star lock washers

and two #10 alignment washers in the upper and lower hole locations of

the left rail. See

Figure 6

.

Figure 6:

Assembling the outer rails (HP System/e rack)

5.

Determine the number of #8-32 x 3/16-inch Phillips pan-head screws with

captive star lock washers required to assemble the inner rails by referring to

Table 1

.

Table 1:

Number of screws required to assemble the inner rails

Switch

Number of #8-32 x 3/16-inch

Screws

SAN Switch 2/32

12

SAN Switch 2/16

10

SAN Switch 2/8

14

Section	Page
Pen-and-ink Changes	2
Page Additions	2
Installing the Switch in a Rack Using the SAN Switch Universal Rack Mount Kit	3
Figure 1: SAN Switch 2/16 rack-mounted switch	3
Figure 2: Installing the rear mounting brackets (HP 9000 Series or comparable EIA rack)	5
Figure 3: Installing the rear mounting brackets (HP System/e rack-left rear upright)	6
Figure 4: Installing the outer rails (HP 9000 Series or comparable EIA rack)	7
Figure 5: Assembling the outer rails (HP 9000 Series or comparable EIA rack)	8
Figure 6: Assembling the outer rails (HP System/e rack)	9
Table 1: Number of screws required to assemble the inner rails	9
Figure 7: Assembling the inner rails	11
Figure 8: Assembling the inner rails on a SAN Switch 2/8 with plenum	12
Figure 9: Installing the switch into a rack (HP 9000 Series or comparable EIA rack)	13

HP StorageWorks 2/32 SAN switch universal rack mount kit installation addendum - Page 9

Assembling the outer rails (HP System/e rack)

Page 9 highlights