Home » HP Manuals » Storage Devices » HP StorageWorks 2/32 » Manual Viewer

HP StorageWorks 2/32 SAN switch universal rack mount kit installation addendum - Page 6

Installing the rear mounting brackets (HP System/e rack-left rear upright)

View all HP StorageWorks 2/32 manuals

Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

Installing the Switch in a Rack Using the SAN Switch Universal Rack Mount Kit - For an HP System/e rack, install each of the two rear mounting brackets with (2) #10-32 x 1/2-inch Phillips pan-head screws and (2) #10 alignment washers as shown in Figure 3. Figure 3: Installing the rear mounting brackets (HP System/e rack-left rear upright) 4 Addendum Pg HP StorageWorks SAN Switch 2/8|16|32 Installation Guide

Section	Page
Pen-and-ink Changes	2
Page Additions	2
Installing the Switch in a Rack Using the SAN Switch Universal Rack Mount Kit	3
Figure 1: SAN Switch 2/16 rack-mounted switch	3
Figure 2: Installing the rear mounting brackets (HP 9000 Series or comparable EIA rack)	5
Figure 3: Installing the rear mounting brackets (HP System/e rack-left rear upright)	6
Figure 4: Installing the outer rails (HP 9000 Series or comparable EIA rack)	7
Figure 5: Assembling the outer rails (HP 9000 Series or comparable EIA rack)	8
Figure 6: Assembling the outer rails (HP System/e rack)	9
Table 1: Number of screws required to assemble the inner rails	9
Figure 7: Assembling the inner rails	11
Figure 8: Assembling the inner rails on a SAN Switch 2/8 with plenum	12
Figure 9: Installing the switch into a rack (HP 9000 Series or comparable EIA rack)	13