HP StorageWorks 2/32 SAN switch universal rack mount kit installation addendum - Page 3

Installing the Switch in a Rack Using the SAN Switch Universal Rack Mount Kit

1

Addendum Pg

HP StorageWorks SAN Switch 2/8|16|32 Installation Guide

Installing the Switch in a Rack Using the SAN Switch Universal

Rack Mount Kit

This section provides instructions for installing the SAN Switch 2/32, SAN

Switch 2/16, or SAN Switch 2/8 in an HP System/e rack, or in an HP 9000 Series

or comparable EIA rack using the SAN Switch Universal Rack Mount Kit, part

number 331148-B21.

Figure 1:

SAN Switch 2/16 rack-mounted switch

Note:

The Universal Rack Mount Kit installation requires two technicians.

The following items are required to install the switch in a rack:

■

SAN Switch 2/32, SAN Switch 2/16, or SAN Switch 2/8

■

Power cables

■

#2 Phillips screwdriver

■

7/16-inch wrench or socket

■

The SAN Switch Universal Rack Mount Kit rails and rail mounting hardware

listed below:

(2) Rear mounting brackets

Section	Page
Pen-and-ink Changes	2
Page Additions	2
Installing the Switch in a Rack Using the SAN Switch Universal Rack Mount Kit	3
Figure 1: SAN Switch 2/16 rack-mounted switch	3
Figure 2: Installing the rear mounting brackets (HP 9000 Series or comparable EIA rack)	5
Figure 3: Installing the rear mounting brackets (HP System/e rack-left rear upright)	6
Figure 4: Installing the outer rails (HP 9000 Series or comparable EIA rack)	7
Figure 5: Assembling the outer rails (HP 9000 Series or comparable EIA rack)	8
Figure 6: Assembling the outer rails (HP System/e rack)	9
Table 1: Number of screws required to assemble the inner rails	9
Figure 7: Assembling the inner rails	11
Figure 8: Assembling the inner rails on a SAN Switch 2/8 with plenum	12
Figure 9: Installing the switch into a rack (HP 9000 Series or comparable EIA rack)	13

HP StorageWorks 2/32 SAN switch universal rack mount kit installation addendum - Page 3

Installing the Switch in a Rack Using the SAN Switch Universal Rack Mount Kit

Page 3 highlights