HP Tc2100 HP Server Novell NetWare Installation Guide (including v 6.5) - Page 19
Continue Installation, Basic, NetWare File Server, Copy Files, Advanced, When prompted
View all HP Tc2100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
17. The NetWare 6.5 installation will begin the preliminary DOS file copy. When complete, select and load the proper drivers for the following subsystems: Storage Adapters - varies by server model Network Adapters - varies by server model 18. Create the SYS: volume. The default is 4 GB, which is a satisfactory size for most installation types. 19. Once the SYS: volume has been created, the NSS Management Utility screen is presented where additional disk operations can be performed. This step is optional, and can be skipped by selecting Continue Installation. 20. The NetWare 6.5 installation will begin the system file copy and will load the Installation GUI when complete. Note Software RAID 5, although available as an option by selecting RAID Devices, will not be supported by Novell or HP until at least NetWare 6.5 Support Pack 1. 21. When the GUI loads, you have the option to choose a server type based upon the anticipated use of the server. This option is called a Pattern Deployment, which customizes certain settings during installation to optimize the server for the pattern selected. Unless you are installing a server to meet one of the listed Patterns, HP recommends selecting Basic NetWare File Server. 22. Review the summary screen to ensure that you meet the minimum hardware requirements for the selected server pattern type, and then select Copy Files. 23. When prompted, insert the NetWare 6.5 Products CD. Allow the CD ample time to mount (about 30 seconds), then select OK to continue the file copy process. 24. When prompted, insert the NetWare 6.5 License diskette. The first license file required is for cryptography and will have an .NFK extension. It should be located in the \License subdirectory on the diskette. 25. Select the Network Protocols for the installed network cards and enter the appropriate information. IP and/or IPX can be selected from the Main screen. Advanced settings can be entered by selecting the Advanced tab from the Main screen. 26. If desired, enter the server DNS host name and the Name Server IP Address. This information is optional and can be skipped if DNS is not used on the network.