HP Visualize J5000 hp workstations - hp-ux 10.20 graphics administration guide - Page 98

-quiet Turns off verbose logging. This is the default. -n Lists changes to key mappings without actually making those changes. -e Specifies a remapping expression to be executed. -pm, -p Prints the current modifier map to the standard output. This is the default. -pk Prints the current keymap table to the standard output. -pp Print the current pointer map to the standard output. Specifies that the standard input should be used for the input file. Specifies a particular key mapping file to be used. Specifying Key Remapping Expressions Whether you remap a single key "on the fly" with a command-line entry or install an entire new keyboard map file, you must use valid expressions in your specification, one expression for each remapping. A valid expression is any one of the following: Valid xmodmap Expressions To do this... Use this expression... Assign a key symbol to a keycode keycode = Replace a key symbol expression with another. keysym = Clear all keys associated with a modifier key. clear Add a key symbol to a modifier. add = Remove a key symbol from a modifier. remove = keycode Refers to the numerical value that uniquely identifies each key on a keyboard. Values may be in decimal, octal, or hexadecimal. keysym Refers to the character symbol name associated with a keycode; for example, KP_Add. modifier Specifies one of the eight modifier names: Shift, Control, Lock, Mod1, Mod2, Mod3, Mod4, and Mod5. On Hewlett-Packard keyboards, the lock modifier is set to the key. However, any of the modifiers can be associated with any valid key symbol. Additionally, you can associate more than one key symbol with a modifier (such as Lock = Shift_R and Lock = Shift_L), and you can associate more than one modifier with a key symbol (for example, Control = Caps_Lock and Lock = Caps_Lock). Page 98 Graphics Administration Guide for HP-UX 10.20