Husqvarna RZ54i Owners Manual - Page 26
SmartSwitch Ignition, Resetting ignition system passcode
View all Husqvarna RZ54i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
OPERATION SmartSwitch Ignition NOTES: The default passcode [321] is preset at the factory. For safety and security, the passcode should be changed prior to use. Resetting ignition system passcode 1. To initialize the ignition system, press the START/ STOP (S/S) button on the ignition switch or sit on the seat. The blue indicator will blink, showing the system is operational. 2. Using the lower buttons, press and hold the (1) and (3) buttons at the same time for three seconds. The blue indicator will then be lit continuously, signalling the system is ready to accept a new code. 1 2 1. Start/Stop Button 2. Numbered buttons Press buttons to enter new passcode 3. Using the lower buttons, enter a desired code of numbers from one to five digits and then press the S/S button. The indicator will blink green to signal the passcode has been accepted. 4. If the S/S button blinks red, the passcode reset has not been accepted. Wait for the S/S button to return to blinking blue and retry the programming, starting at Step 1. 8058-235 Enter passcode and then press the S/S button 8058-236 26