Husqvarna RZ54i Owners Manual - Page 45
Adjusting the Mower Deck, Leveling deck
View all Husqvarna RZ54i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
MAINTENANCE Adjusting the Mower Deck Leveling deck Adjust the deck while the mower is on a level surface. Make sure the tires are inflated to the correct pressure. See Technical Data / Transmission. If tires are under or over inflated, the deck cannot be properly adjusted. Raise the deck to the highest (transport) position. The deck should be adjusted slightly higher in the rear. NOTE: To insure accuracy of leveling procedure, mower deck drive belt must be installed prior to leveling deck. 1. Wear heavy gloves. Turn each outer blade tip to align side to side. 2. Measure from the floor surface up to the bottom of the blade tip on the discharge side of the mower deck. Record this measurement. 3. Move to the opposite side, check that the measurement is the same. If adjustment is required-with a ¾" or adjustable wrench, turn the lift link adjustment nuts on either side counter clockwise to lower or clockwise to raise. Adjust until both side-to-side measurements are equal. Set blades to begin alignment 80158-166 4. Turn either outer blade to align with the deck in front-to-rear manner. If the front blade tip does not measure 1/8" to ½" higher in the rear, follow the front adjustment instructions that follow. 5. With a 5/8 or adjustable wrench, turn the nuts on the front suspension linkage. Clockwise raises the front of the mower, counterclockwise will lower the front. Adjust nuts until rear of mower deck is positioned level to 1/8" higher in the rear than the side-to-side measurement. NOTE: This will place the mower deck in a standard measurement position. Depending on the type of grass being mowed or environmental conditions, additional adjustments may be required to achieve the desired cut. Lift link adjustment nut Deck front adjustment nuts 8058-030 8058-031 45