Husqvarna ST 230 Owner Manual - Page 21
To clean the product, Troubleshooting
View all Husqvarna ST 230 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
A B To clean the product • Clean plastic parts with a clean and dry cloth. • Do not use a high pressure washer to clean the product. C • Do not flush water directly on the motor. • Use a brush to remove leaves, grass and dirt. Troubleshooting Troubleshooting Problem The product does not start Possible cause The safety ignition key is not inserted. The product is out of fuel. The ON/OFF key is OFF. The choke is in OFF (CLOSE) position. The primer is not depressed. The engine is flooded. The spark plug cable is not connected. The spark plug is bad. There is water in the fuel or the fuel is too old. There is vapor locked in the fuel line. Other causes. The fuel switch (if equipped) is in CLOSE (OFF) position. The throttle is in STOP position. Solution Insert the safety ignition key. Fill the fuel tank with fresh, clean gasoline. Move the ON/OFF key to ON position. Move the choke to ON (FULL, OPEN) position. Press the primer. Wait a few minutes before restarting, DO NOT prime. Restart the engine while full throttle and the choke in OFF (CLOSE) position. Connect the cable to the spark plug. Replace the spark plug. Empty the fuel tank and carburetor. Fill the fuel tank with fresh, clean gasoline. Make sure that all the fuel line is below the outlet of the fuel tank. The fuel line should run continuously down from fuel tank to carburetor. Inspect the starting procedures carefully in this manual. Turn the fuel switch to OPEN (ON) position. Move the throttle to FAST position. 694 - 003 - 07.11.2019 21