IBM 84903bu User Guide - Page 41
Number, DIMMs, Connector, sequence
UPC - 000435882073
View all IBM 84903bu manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
4. Locate the DIMM connectors on the system board. Determine the connectors into which you will install the DIMMs. Install the DIMMs in the sequence shown in the following table. Number of DIMMs One DIMM Two DIMMs (interleaved configuration) Three DIMMs Four DIMMs (interleaved configuration) Connector sequence 1 1, 3 Not supported 1, 3, 2, 4 Attention: To avoid breaking the retaining clips or damaging the DIMM connectors, open and close the clips gently. 5. Open the retaining clips and, if necessary, remove any existing DIMM. 6. Touch the static-protective package that contains the DIMM to any unpainted metal surface on the server. Then, remove the new DIMM from the package. 7. Turn the DIMM so that the DIMM keys align correctly with the slot. 8. Insert the DIMM into the connector by aligning the edges of the DIMM with the slots at the ends of the DIMM connector. Firmly press the DIMM straight down into the connector by applying pressure on both ends of the DIMM simultaneously. The retaining clips snap into the locked position when the DIMM is firmly seated in the connector. If there is a gap between the DIMM and the retaining clips, the DIMM has not been correctly installed. Open the retaining clips, remove the DIMM, and then reinsert it. If you have other options to install or remove, do so now; otherwise, go to "Completing the installation" on page 44. Chapter 2. Installing options 27