IBM 84903bu User Guide - Page 49
Installing, non-hot-swap, drive
UPC - 000435882073
View all IBM 84903bu manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Installing a non-hot-swap SATA hard disk drive in bay 4, 5, 6, or 7 Some server models come with non-hot-swap SATA hard disk drives. Before you install a non-hot-swap SATA hard disk drive, read the following information: v Read the documentation that comes with the drive for cabling instructions. v Route the cable before you install non-hot-swap drives. Do not block the airflow from the fans. v You can install four non-hot-swap SATA hard disk drives in the server. v Install the drives in ascending order by bay number. Attention: Disconnect all power from the server before removing or installing a non-hot-swap hard disk drive. To install a non-hot-swap SATA hard disk drive, complete the following steps: 1. Read the safety information that begins on page v and "Installation guidelines" on page 19. 2. Turn off the server and peripheral devices and disconnect all external cables and power cords. 3. Unlock the side cover (the bezel will not disengage from the server if the cover is locked). 4. Remove the side cover and lower bezel (see "Removing the side cover" on page 22 and "Removing the two-piece bezel" on page 23). 5. Touch the static-protective package that contains the drive to any unpainted metal surface on the server; then, remove the drive from the package and place it on a static-protective surface. 6. Align the drive assembly with the guide rails in the bay (the connector end of the drive goes in first). Chapter 2. Installing options 35