IBM 84903bu User Guide - Page 47
hot-swap, drives, Installing, simple-swap, drive
UPC - 000435882073
View all IBM 84903bu manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
installing hard disk drives. See the ServeRAID documentation on the IBM ServeRAID Support CD for additional information about RAID operation and complete instructions for using ServeRAID Manager. 7. If you are installing additional hot-swap hard disk drives, do so now. If you have other options to install or remove, do so now; otherwise go to "Completing the installation" on page 44. IDs for hot-swap hard disk drives The hot-swap-drive backplane controls the IDs for the internal hot-swap drive bays. The following table lists the IDs for the hard disk drives and backplane that are connected to one channel in hot-swap models. In the typical configuration, the standard hard disk drives and backplane are connected to channel A. Device ID Drive bay 4 0 Drive bay 5 1 Drive bay 6 2 Drive bay 7 3 Installing a simple-swap SATA hard disk drive in bay 4, 5, 6, or 7 Some server models come with simple-swap SATA hard disk drives, which are accessible from the front of the server. Before you install a simple-swap SATA hard disk drive, read the following information: v You can install four simple-swap SATA hard disk drives in the server. v Install the drives in ascending order by bay number. Attention: Simple-swap hard disk drives are not hot-swappable. Disconnect all power from the server before removing or installing a simple-swap hard disk drive. Chapter 2. Installing options 33