Icom IC-M412 Instruction Manual - Page 21
Dsc Operation
View all Icom IC-M412 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
6 DSC OPERATION n MMSI code programming The 9-digit MMSI (Maritime Mobile Service Identity: DSC self ID) code can be programmed at power ON. This code programming can be performed only twice. After the code programming, it can be changed only by your dealer or distributor. q Turn OFF the power. w While holding down [MMSI](MENU), turn ON the power to enter the MMSI code programming mode. e After the display appears, release [MMSI](MENU). r Push [MENU] to enter the DSC menu. t Push [Y] or [Z] to select "MMSI," then push [ENT]. • A cursor starts blinking. y Push [Y] or [Z] to select the specified MMSI code. • Push [CH/WX] or [16] to move the cursor forward or backward. u After programming the 9-digit MMSI code, push [ENT]. • "CONFIRMATION" scrolls in the channel comment display. i P ush [ENT], then input the same MMSI code as step y for the confirmation. o P ush [ENT] to set the code. • Selects to normal operation. • Push [CLR] to cancel and exit the programming mode, if de- 5 sired. • If a different code is input, "INCORRECT" appears. In that case, 6 push [ENT] to repeat steps y to i again. D MMSI code check The 9-digit MMSI (DSC self ID) code can be checked. ➥ W hile in the stand-by mode, hold down [MMSI](MENU) for 1 second to display the 9-digit MMSI (DSC self ID) code. • T he MMSI code is displayed and scrolls in the channel comment display. • W hen no MMSI code is programmed, "NO MMSI" appears and warning alarm sounds. Scrolls Scrolls 13