Insignia NS-STR514 User Manual (English) - Page 14

Insignia NS-STR514 Stereo Receiver with Bluetooth 2 To stop automatically presetting stations, press the MEMO button on the remote control or the MEMORY button on the receiver again. Notes • • Weak FM stations cannot be memorized. Auto preset can only be performed when you select the FM as the input source. However, you can manually preset AM stations or weak stations. Manually presetting radio stations 1 Tune to the station you want to preset. 2 Press the MEMO button on the remote control or the MEMORY button on the receiver. MEM blinks on the display. Tuning to preset stations 1 Select the TUNER as the input source. 2 Press TUNE/PRESET to select the preset mode. PRESET lights up. 3 Press the or buttons on the receiver or the PRESET / buttons on the remote control to select the preset station you want. OR OR 3 Select a preset number between 1 and 30 by pressing: • The or buttons on the receiver. -OR• The PRESET / buttons on the remote control. OR -OR- Enter the preset number using the number keys on the remote control. Note When using the numeric keypad on the remote control, if your number is greater than nine, enter the first digit, then enter the second digit within two seconds. Listening to FM stereo broadcasts • While listening to an FM broadcast, press the MO/ST button. Each time this button is pressed, the FM mode changes as follows: • Stereo mode-ST lights up. • Mono mode-ST turns off. -OR• The number keys on the remote control. Notes • • • • When using the numeric keypad on the remote control, if your number is greater than nine, enter the first digit, then enter the second digit within two seconds. When using the numeric keypad, the station is stored automatically without pressing the MEMORY button on the receiver or the MEMO button on the remote control. A stored frequency is erased from memory by storing another frequency in its place. If MEM goes off, start again from step 3. 4 Confirm your selection by pressing: • The MEMORY button on the receiver. -OR- • The MEMO button on the remote control. 5 Repeat this procedure to memorize additional stations. Recording Use your stereo receiver as a switch to connect your audio sources to the audio recording device that is connected to AUX 1 OUT or AUX 2 OUT. You can record audio from the currently selected receiver input source. Notes • • • When recording, the audio signals from AUX inputs cannot be recorded on the same AUX output jacks. (For example, the audio signal from AUX 1 IN cannot be record on AUX 1 OUT.) The volume, tone (bass and treble), and balance settings have no effect on the recording signals. When you select the tuner or CD as a recording source, recording may be made on AUX 1, AUX 2, or both simultaneously. 12 www.insigniaproducts.com