Intel D925XECV2 English Manual Product Guide - Page 68
Table 11., BIOS Error Messages
View all Intel D925XECV2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Intel Desktop Board D925XECV2/D925XEBC2 Product Guide Table 11. BIOS Error Messages (continued) Error Message CMOS Date/Time Not Set DMA Error FDC Failure HDC Failure Checking NVRAM..... Update OK! Updated Failed Keyboard Is Locked Keyboard Error KB/Interface Error Memory Size Decreased Memory Size Increased Memory Size Changed No Boot Device Available Off Board Parity Error On Board Parity Error Parity Error NVRAM / CMOS / PASSWORD cleared by Jumper Pressed Explanation The time and/or date values stored in CMOS are invalid. Run Setup to set correct values. Error during read/write test of DMA controller. Error occurred trying to access diskette drive controller. Error occurred trying to access hard disk controller. NVRAM is being checked to see if it is valid. NVRAM was invalid and has been updated. NVRAM was invalid but was unable to be updated. The system keyboard lock is engaged. The system must be unlocked to continue to boot. Error in the keyboard connection. Make sure keyboard is connected properly. Keyboard interface test failed. Memory size has decreased since the last boot. If no memory was removed, then memory may be bad. Memory size has increased since the last boot. If no memory was added, there may be a problem with the system. Memory size has changed since the last boot. If no memory was added or removed, then memory may be bad. System did not find a device to boot. A parity error occurred on an offboard card. This error is followed by an address. A parity error occurred in onboard memory. This error is followed by an address. A parity error occurred in onboard memory at an unknown address. NVRAM, CMOS, and passwords have been cleared. The system should be powered down and the jumper removed. CMOS is ignored and NVRAM is cleared. User must enter Setup. 68