Intel SE7210TP1-E User Guide - Page 31

Server Utilities 5. A blue screen will be displayed and the recovery process will automatically run. The system will continue to beep throughout the recovery process. The recovery process is complete when the beeping stops. 6. Remove the diskette. 7. Power down and unplug the system from the AC power source. 8. Move the BIOS recovery jumper at J1D1 back to the original position, covering pins 13 and 14. 9. Plug the system into the AC power source and power it up to confirm that the recovery was successful. Clearing the Password If the user or administrator password(s) is lost or forgotten, moving the password clear jumper into the "clear" position clears both passwords. The password clear jumper must be restored to its original position before a new password(s) can be set. The password clear jumper is located on jumper block J1D1. 1. Power down the system and disconnect the AC power. 2. Open the server chassis. 3. Move the jumper from pins 5 and 6 to the Clear Password position, covering pins 6 and 7. 4. Reconnect the AC power, power up the system. 5. Power down the system and disconnect the AC power. 6. Return the Password Clear jumper to the spare location, covering pins 5 and 6. 7. Close the server chassis. Clearing the CMOS If you are not able to access the BIOS setup screens, the CMOS Clear jumper will need to be used to reset the configuration RAM. The CMOS Clear jumper is located on jumper block J1D1. 1. Power down the system and disconnect the AC power. 2. Open the server. 3. Move the jumper from pins 1 and 2 to the Clear CMOS position, covering pins 2 and 3. 4. Reconnect the AC power, power up the system. 5. When the system begins beeping, power it down and disconnect the AC power. 6. Return the CMOS Clear jumper to the original location, covering pins 1 and 2. 7. Close the server chassis, reconnect the AC power and power up the system. Intel Server Board SE7210TP1-E User Guide 31