JVC KD-X260BT Instruction Manual America - Page 41
supports Audio/Video Remote Control Profile AVRCP.
View all JVC KD-X260BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
TROUBLESHOOTING Symptom Remedy "CHECK ANTENNA" Check that the antenna and its connection are in good condition. "CHECK TUNER" Make sure the SiriusXM Vehicle Tuner is connected to the unit. SiriusXM® Radio "NO SIGNAL" Make sure the antenna is mounted outside the vehicle. "SUBSCRIPTION UPDATED - PRESS ENTER TO CONTINUE." Your subscription is updated. Press the volume knob to continue. "CODE ERROR" Make sure you have entered the correct pass code. (Page 14) "NO CONTENT" There is insufficient content to start TuneScan. "SCAN CANCEL" TuneScan has been aborted. No Bluetooth device is • Search from the Bluetooth device again. detected. • Reset the unit. (Page 3) Pairing cannot be made. • Make sure you have entered the same PIN code to both the unit and Bluetooth device. • Delete pairing information from both the unit and the Bluetooth device, then perform pairing again. (Page 15) Bluetooth® Echo or noise is heard during a phone conversation. • Adjust the microphone unit's position. (Page 15) • Check the [ECHO CANCEL] setting. (Page 17) Phone sound quality is poor. • Reduce the distance between the unit and the Bluetooth device. • Move the car to a place where you can get a better signal reception. Symptom Remedy Voice calling method is not successful. • Use voice calling method in a more quiet environment. • Reduce the distance from the microphone when you speak the name. • Make sure the same voice as the registered voice tag is used. Sound is being interrupted or skipped during playback of a Bluetooth audio player. • Reduce the distance between the unit and the Bluetooth audio player. • Turn off, then turn on the unit and try to connect again. • Other Bluetooth devices might be trying to connect to the unit. Bluetooth® The connected Bluetooth audio player cannot be controlled. • Check whether the connected Bluetooth audio player supports Audio/Video Remote Control Profile (AVRCP). (Refer to the instructions of your audio player.) • Disconnect and connect the Bluetooth player again. "PLEASE WAIT" The unit is preparing to use the Bluetooth function. If the message does not disappear, turn off and turn on the unit, then connect the device again. "NOT SUPPORT" The connected phone does not support Voice Recognition feature or phonebook transfer. "NO ENTRY"/"NO PAIR" There is no registered device connected/found via Bluetooth. "ERROR" Try the operation again. If "ERROR" appears again, check if the device supports the function you have tried. ENGLISH 37