JVC KW-M740BT Instruction Manual America - Page 81
Installing the unit, Supplied accessories for, installation, Installation procedure, Microphone unit - wiring harness
View all JVC KW-M740BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
• Do not press hard on the panel surface when installing the unit to the vehicle. Otherwise scars, damage, or failure may result. • Reception may drop if there are metal objects near the Bluetooth antenna. Bluetooth antenna unit ÑÑSupplied accessories for installation 1 x1 2 (Black 1 m) x1 3 (3 m) x1 4 (M5 x 8 mm) x6 5 (M5 x 8 mm) x6 ÑÑInstallation procedure 1) To prevent a short circuit, remove the key from the ignition and disconnect the ¤ terminal of the battery. 2) Make the proper input and output wire connections for each unit. 3) Connect the speaker wires of the wiring harness. 4) Connect the wiring harness wires in the following order; ground, battery, ignition. 5) Connect the wiring harness connector to the unit. Connection/Installation 6) Install the unit in your car. 7) Reconnect the ¤ terminal of the battery. 8) Perform the Initial Setup. See Initial setup (P.7). Installing the unit 4 or 5 Car Bracket 4 or 5 NOTE • Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip). ÑÑMicrophone unit 1) Check the installation position of the microphone (accessory 3). 2) Clean the installation surface. 3) Remove the separator of the microphone (accessory 3), and stick the microphone to the place shown below. 4) Wire the microphone cable up to the unit with it secured at several positions using tape or other desired method. 5) Adjust the direction of the microphone (accessory 3) to the driver. 3 Fix a cable with a commercial item of tape. English 81