JVC KY-F70U KY-F70U Computer Imaging Camera Instructions (827KB) - Page 42
Synchronizing flash and FREEZE
View all JVC KY-F70U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
5. Various recording methods (continued) Synchronizing flash and FREEZE To activate the flash when inputting FREEZE, use the REMOTE terminal. The REMOTE terminal located in the rear is also used to freeze an image using an external device other than the FREEZE button on the rear of the main unit. Explanation of terminals ( ੬ page 12) ● In response to FREEZE input, KY-F70 outputs a flash signal for the CCD accumulation period of the next frame. ● The time required for flash output from FREEZE input depends on the timing of the FREEZE @inpu@t an@d s@hutt@er s@peed. In addition, the pulse length of the flash output differs depending on the shutter speed. ● The slow shutter will also be used when the unit is in the SXGA mode or FINE mode of the VGA mode with shutter speed of 1/7.5 sec. or slower, or when in the DRAFT mode of the VGA mode with shutter speed of 1/30 sec. or slower. ● Since the above diagram is the timing chart when in the SXGA mode, CCD OUT and ANALOG OUT are synchronous. However, the timing of ANALOG OUT will be asynchronous with CCD OUT when in the VGA mode and there will also be no WEN output. ● When in the VGA mode, FREEZE input is ignored until the FREEZE screen is completely displayed on the monitor. ● Even for the SXGA mode, FREEZE input for continuous frames are not recognized and FREEZE input interval for high speed shutters also require a minimum of 2 frames (270ms). ● When the FREEZE cancel mode is set to MANUAL, the FREEZE input for FREEZE cancellation will not output a FLASH signal or WEN. E42 Timing chart (SXGA mode) FREEZE VD (Internal) EXP (CCD accumulation period) FLASH CCD OUT ANALOG OUT WEN a. High speed shutter only FREEZE VD (Internal) EXP (CCD accumulation period) FLASH CCD OUT ANALOG OUT WEN b. Combined with slow shutter