Jabra GN9350 User Manual - Page 11

GN9350e GN9330e GN9330e USB 4.3 Conference calling Conference calling lets several headsets join together for a call. The primary headset (A) + 3 extra headsets (B) can join a conference call initiated by the primary headset. (See illustration.) Making conference calls 1. Remove primary headset from base; make sure link is established. Indicators on base and headset are flashing. 2. Place secondary headset in primary headset's base. -> Primary base's telephone and USB mode indicators, and secondary headset's link indicator, will light for 2 seconds. 3. Remove secondary headset from primary headset's base. 4. After a 4-pitch tone is heard in the primary headset, press the silver-colored talk button. 5. When the GN9350e is linked up to more than one headset in conferencing mode the product is not TT4 compliant. A B B B B B 2 sec A A A Important: Steps 2 to 4 may be repeated twice for 2 more secondary headset participants. 6. Use the primary headset to establish the initial conversation. To join additional headsets at any point during a call in progress, you may add secondary headsets to form a conference call. A maximum number of 4 headsets (1 master plus up to 3 secondary) may join a conference call. 14 Ending conference calls for all participants 1. Place primary headset in its base, or press its talk button. -> The conference call is now terminated for all participants. Note: If the conference call was made via VoIP, you may need to perform additional steps to end your call. See your VoIP application's user instructions. Also note that the master headset must confirm/permit other members to join a conference. Ending conference calls for a secondary headset only 1. Place secondary headset in its own base, or press its talk button. -> This participant is now terminated from the conference call. GN9350e GN9330e GN9330e USB 4.4 Emergency calling via VoIP Your headset supports quicker emergency calling via VoIP applications (softphone). If the headset is connected to a PC and the PC is screensaver-locked, you can still use the headset to dial emergency services. To call emergency services via VoIP: 1. Put on headset. 2. If the PC is on (even if screensaver-locked), press the base unit's telephone mode button and USB mode button simultaneously for 5 seconds. -> The base will automatically dial the emergency services number. Note: This emergency services feature works only with certain VoIP applications. Please refer to www.jabra.com for more information. GN9350e GN9330e GN9330e USB 4.5 Switching a call from headset to desk telephone handset It's possible to switch a call in progress from the headset to the telephone's handset: 1. Lift the telephone's handset to your ear. 2. Do one of the following: • Place the headset into the charging cradle. • Press the headset's talk button. • Press the base's telephone mode button. -> The headset's link indicator will stop flashing to indicate that the headset-base link has been closed. Important: If using electronic hookswitch on your telephone, do not place the headset into the charging cradle, and do not press the headset´s talk button or press the base´s telephone mode button, as this will disconnect the call. If the headset runs out of battery power, the headset-base link will remain active for up to 2 minutes to allow for battery changing. 15