Kenwood TS-2000 Operation Manual - Page 107
Installing Options, Removing The Bottom Case, Dru-3a Digital Recording Unit
View all Kenwood TS-2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
INSTALLING OPTIONS You will require a Phillips screwdriver when installing the optional units. REMOVING THE BOTTOM CASE When installing the optional DRU-3A or VS-3 unit, remove the bottom case first. 1 Remove the 10 screws. VS-3 VOICE SYNTHESIZER UNIT SWITCH OFF THE POWER AND UNPLUG THE DC POWER CABLE BEFORE BEGINNING INSTALLATION. 1 Remove the bottom case (10 screws). 2 Locate the VS-3 jack. 3 Hold the VS-3 unit with the component side facing up, and insert the VS-3 connector into the VS-3 jack. 2 Lift off the bottom case. DRU-3A DIGITAL RECORDING UNIT SWITCH OFF THE POWER AND UNPLUG THE DC POWER CABLE BEFORE BEGINNING INSTALLATION. 1 Remove the bottom case (10 screws). 2 Locate the DRU-3A connector. 3 Peel off the paper on the cushion attached to the PC board of the transceiver. 4 Replace the bottom case (10 screws). Note: After the installation, you can adjust the VS-3 playback volume by selecting Menu No. 15. Cushion 4 Plug the DRU-3A into the DRU-3A connector of the PC board. 5 Press the top of the DRU-3A to affix it to the cushion. DRU-3A 6 Replace the bottom case (10 screws). Note: After the installation, you can adjust the DRU-3A playback volume by selecting Menu No. 14. 97