Kenwood TS-2000 Operation Manual - Page 23
Rear Panel, Ant 1, Paddle, Ant 430, Ant 1.2g, Dc 13.8v, Panel, Ext.sp1, Ext.cont, Remote, Hf Rx Ant
View all Kenwood TS-2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
REAR PANEL 4 GETTING ACQUAINTED 1 2 3 4 65 8 ANT 2 COM 21 AT ANT 144 ANT 1 GND KEY PADDLE ANT 430 EXT. SP2 EXT. SP1 PANEL 8Ω 8Ω EXT. CONT ACC2 REMOTE ANT 1.2G DC 13.8V HF RX ANT 9 10 11 12 13 14 15 7 q ANT 1 and ANT 2 connectors Connect your primary HF/ 50 MHz antenna to ANT 1. If you are using 2 antennas for the HF/ 50 MHz band, connect the secondary antenna to the ANT 2 connector. w GND post Connect a heavy gauge wire or copper strap between the ground post and the nearest earth ground {page 1}. e KEY and PADDLE jacks The PADDLE jack mates with a 6.3 mm (1/4") 3-conductor plug for connecting a keyer paddle to the internal electronic keyer. The KEY jack mates with a 3.5 mm (1/8") 2-conductor plug for connecting an external key for CW operation. Read "Keys for CW (PANEL and KEY)" {page 3} before using these jacks. r AT connector Mates with the connector on the cable supplied with the external antenna tuner. Refer to the instruction manual supplied with the tuner for more information. t ANT 144 Connect your 144 MHz band antenna to this connector. y ANT 430 Connect your 430/ 440 MHz band antenna to this connector. u ANT 1.2G (TS-2000/ TS-B2000 Optional) Connect your 1.2 GHz band antenna to this connector. i DC 13.8V power input connector Connect a 13.8 V DC power source to this connector {page 2}. Use the cable supplied with the regulated DC power supply. o COM connector Mates with a 9-pin female RS-232C connector for connecting a computer via one of its serial communication ports {page 93}. Also used with the Quick Data Transfer function {page 93}. !0 PANEL connector Connect a cable from the optional separate remote panel (RC-2000) to this connector. !1 EXT.SP1 and EXT.SP2 jacks Mate with a 3.5 mm (1/8"), 2-conductor (mono) plugs for connecting external speakers {pages 3, 78}. !2 EXT.CONT connector Connect your 50 MHz, 144 MHz, 430/ 440 MHz or 1.2 GHz linear amplifier control cable to this connector {page 76}. !3 ACC2 connector Mates with a 13-pin male DIN connector for connecting various accessory equipment, such as an external TNC/ MCP or a RTTY terminal {page 94}. !4 REMOTE connector Mates with a 7-pin male DIN connector for connecting an HF linear amplifier {page 76}. Do not connect 50 MHz, 144 MHz, 430/ 440 MHz, or 1.2 GHz linear amplifier controls to this connector; use the EXT.CONT connector instead. !5 HF RX ANT connector Connect a separate receive-only antenna for HF low bands to this jack (RCA connector) {page 76}. 13